Exploring the Moon will require rovers that can think for themselves – an upcoming NASA mission will test whether they can

NASA is planning to send three small rovers to the Moon with a single instruction: Work out among yourselves how to explore a patch of ground.

The Cooperative Autonomous Distributed Robotic Exploration mission, or CADRE, will land on the side of the Moon facing Earth as part of NASA’s IM-3 launch, planned for late 2026. These rovers will spend roughly two weeks mapping the terrain as a self-guided team. No joystick will control them, and no human will approve each turn.

Three small robotic rovers drive across a sterile warehouse floor. — Engineers test whether the CADRE rovers can drive and coordinate on their own at NASA’s Jet Propulsion Laboratory in Pasadena, Calif. NASA/JPL-Caltech

The rovers will elect a leader among themselves, assign their own tasks and redraw their plans as a group when one of them runs low on charge. If it succeeds, CADRE will be the first time NASA has operated multiple rovers beyond Earth as a single autonomous system.

That achievement will matter well beyond this mission, because NASA is scoping out future missions to the lunar South Pole, where water in the form of ice sits locked in craters that haven’t seen sunlight in billions of years. If researchers can chemically split that ice apart and turn it into propellant and breathable air, it could become the feedstock for a lunar economy built around fuel depots and life support made on the Moon.

Right now, the only demand for that ice comes from government contracts. And an operation that must be babysat from 239,000 miles (384,000 kilometres) away will not easily scale into a market. So, while a full-blown lunar economy is still far off, CADRE is testing whether robots can work unsupervised long enough, and in enough numbers, to keep a lunar operation running month after month.

I’m an aerospace engineering Ph.D. candidate researching guidance, navigation and control for spacecraft in-orbit servicing and active debris removal. I work on the same problem these rovers face: how a machine decides what to do next when it cannot call home for instructions.

Why Earth cannot drive

At the Moon’s South Pole, the terrain itself can cause communication disruptions. Commands reach a rover by way of relay satellites, and crater rims can block the line of sight to those relays. A rover that ventures down into a shadowed crater may lose contact for its entire trip.

Spotty communication doesn’t just make trying to drive annoying. It can cost the rover power it cannot recover.

A polar rover runs on a finite illumination budget. Solar panels charge the battery only while the Sun is up, and on the Moon, sunrise is not a daily event. Night lasts about two Earth weeks, and at the poles, only a few ridges stay lit for long stretches. So for every minute a rover spends idle, awaiting new instructions, it is spending stored energy it cannot replace until the Sun comes back.

Two graphs sharing one time axis that spans a single surface trip. The top graph, stored energy, rises while the rover recharges in sunlight at the start, then falls in a straight line at a constant rate for the rest of the trip. The bottom graph, tasks completed, has two step lines: the autonomous team's keeps stepping up through the shaded communication blackouts, while the ground-commanded team's stays flat through each one, so the gap between the two widens. — In the top image, a rover’s stored energy climbs while it charges in sunlight, then falls at the same rate whether it is working or waiting idly. In the bottom image, the grey bands are communication blackouts. A team waiting on commands from Earth stops until the link returns, while an autonomous team keeps assigning itself work, and the gap that opens between the two lines is work recovered from what would otherwise be dead time. Wanjiku Chebet Kanjumba

Why the pole is the hard case

The lunar poles also come with unique challenges. Sunlight can swing from direct glare to absolute shadow as a rover drives down from a sunlit crater rim to the shadowed floor below, so a camera that worked at the top could go blind at the bottom.

The Moon also doesn’t have GPS satellites like Earth does, so rovers can’t know exactly where they are. They need to build their own maps from what their cameras and sensors see.

Temperatures inside permanently shadowed regions drop below minus 274 degrees Fahrenheit (minus 170 degrees Celsius). And the Moon’s dust is more dangerous than it sounds. An electric charge lifts it off the ground, and billions of years of tiny meteorite strikes have left every grain sharp and jagged.

That dust grinds at the wheel bearings and works past the seals. Keeping it out of the rover’s moving parts is still an unsolved problem. The dust can also film over the camera lenses that navigation depends on, leaving a rover unable to see where it is going or move safely.

Why one rover is not enough

Sending a single rover to check out a crater on the Moon is a risky mission. If it gets stuck, the campaign ends. If its instruments fail, no second machine can take the measurements. Multirobot teams distribute that risk and split up the jobs. One rover might carry the sensors and another the drill, while a lander positioned on a sunlit ridge acts as the power and communications hub.

Under a communications blackout, a rover team that waits for its commands from Earth has to stop. An autonomous team reassigns tasks among itself, selecting the next objective that it can reach and complete with the amount of power it has left. Dead time becomes work time.

In ground testing at NASA’s Jet Propulsion Laboratory, the CADRE rovers achieved this coordination. Faced with unexpected obstacles, they replanned paths as a group, and when one rover’s battery ran low, the whole team paused so they could continue together.

A diagram showing how different rovers and a lander communicate and work together on the lunar surface — A prospecting team splits the work. A lander on the sunlit rim supplies power and relays communications, while a rover and a drill work the permanently shadowed crater floor below, where water ice may be trapped and no sunlight reaches. Once they drop past the rim’s radio horizon, they are out of contact and have to divide the tasks and manage their own power. Wanjiku Chebet Kanjumba

What remains uncertain

A campaign at the lunar South Pole would need to run for months, and no robot team has yet worked that hard, for that long, that far from help. Engineers are developing ways for rovers to navigate without satellite positioning and to make decisions onboard, but that software still has to be tested on the surface.

Meanwhile, as of mid-August 2026, China’s Chang’e-7 mission is waiting at Wenchang, the launch site on Hainan Island in China, with liftoff expected by the end of the year. Its lander, rover and hopping probe are meant to work at the pole as a team, with the probe built to leap into permanently shadowed craters. If the U.S. wants to keep pace, it will need its own robots that coordinate without supervision.

Finally, there is no agreed way for a rover built by one company to hand a task to a tool built by another, or to decide which one works the crater floor first. As autonomous rover teams improve, the groups building them will have to work out those rules.

CADRE will tell scientists whether three small rovers can reason together on the Moon. The harder question is whether a dozen different machines from different builders can do the same thing, reliably, for years.